Sunday, January 24, 2010

Hardwood Flooring Ontario Does Hardwood Flooring Really Have To Be Installed Perpendicular To The Joists Under The Sub Floor?

Does hardwood flooring really have to be installed perpendicular to the joists under the sub floor? - hardwood flooring ontario

I'm the installation of wood on the ground floor of my house split level. They took a halfwall between kitchen and dining room. Would you recommend the beams in parallel, but all have read what I have to install vertically. The floor is recommended in parallel to the length of the hall is my tables in parallel down to the bar. Advice or ideas would be helpful.

10 comments:

BN'W said...

If you have 3 add / 4 "plywood before installing it was strong enough. If you have problems later.

rock said...

The reason for this is the time to rotate the beam ........ Follow the instructions, or you will not regret in the long term.

joe j said...

Warp ground are awful and no one notices it until you sell your home inspector and a smart Alec comes in rolls and a tennis ball on the ground and begin to laugh at you.

Or cable gradual you do not see, but it hurts the value of your home seriously, because potential buyers distorted thinking that the bars are always, even foundation problems rather warped boards.

The price of what you need to do to install parallel is simply disproportionate to the benefits. I always say to add sister boards, add the thickness of the subfloor of plywood to pray, then. It's easier to just do not right the first time!

So, I mean, if you have not yet purchased your land, but some advice: do not. Soil quality is the price, and life at home, you forget the additional cost of less importance.

Remember, the floor in the hall for a few days off before installation.

Good luck to you - seems to care so much ground, then you are finished and your roomlooks really good!

wildrice... said...

are thin and serve only to maintain their weight

rangedog said...

In older houses, where I worked, there were good wood floor was installed perpendicular to the beam, was installed in the basement in a 45degree angle to the ceiling beams and wooden floors. The Council is the tape on the floor, I understand.

Bearcat said...

Make sure you have good soil and can be installed under heavt in any desired angle, even at 45 degrees. The house of my mother, parallel to the beam 60 and no problems

buff j said...

depends on the thickness of the basement. Older homes have the tongue of the boards on 3 / 4 "or 1 cm thick and can install a wood floor in any direction. Most newer homes have a basement thin layers of wood, and they have to give some", in which case that you install your board perpendicular to the rafters

ohiogoos... said...

If the reason.
If you can strengthen your subfloor have any problems in the future.

I was Thinking said...

You can increase your basement in order to give enough support so that you can have it your way

jimbothe... said...

The reason that the longest wall is adjusted in the room that it is easier and less noticeable if the room is just off the square. If you have two layers of storage that can safely be installed perpendicular to the top of the beams from home, and the installation of 3 / 4 "hardwood floors as you want.

Post a Comment